5250 Deck Gauge
The 5250 Deck Gauge provides an accurate and clear display of the tank level right at the point of filling. It is designed to be installed near to the tank filler to help avoid refuelling spills and prevent water pollution incidents.
It has a clear blue LED digital display that automatically dims at night to preserve night vision mounted in an attractive stainless steel bezel that is easy to install.
3271 Fuel Level Sender
The 3271 Volumetric Fuel Sender provides very accurate measurement and output of either the remaining Fuel LEVEL or the remaining Fuel VOLUME to the NMEA2000 network.
It is accurate to ±2% and automatically provides a stilling action to dampen out fuel slosh in the tank to maximise accuracy when conditions are rough or the boat is travelling quickly.
The 3271 can be programmed with up to 100 volumetric points, so that it offers the most accurate indication of the remaining VOLUME of fuel in the tank. This volume information can then be displayed on any NMEA2000® enabled display, wherever it is required.
3281 Water Level Sender
The 3281 Water Level Sender will measure the water level in the fresh water tanks. They provide a ±2% accurate tank level to the NMEA2000® marine network.
They are robustly constructed in stainless steel with no moving parts to stick or fail in service. They are easily cut to length to suit tank depths from 250mm to 2 metres.
4272/4282 Hydrostatic Side Mount Sender
The 4272 Sender is for Fuel Tanks, the 4282 Sender is for Fresh Water Tanks.
They are available with a range of attachment threads to suit most applications including ¼” BSP, SAE J1926-1-4 and M12. The senders have a user settable device instance (address) switch to make installation easy and to allow up to 16 senders of each type on a single network.
4620-4626 GENERAL PURPOSE 4-20MA PRESSURE SENSORS
The Oceanic Systems’ Pressure Sensor range can monitor a wide range of liquids or gas pressures in the marine environment. They have high stability and feature enhanced anti-interference and surge protection and output a steady 4-20mA and 0-10V signal.
4650-4655 SUBMERSIBLE HYDROSTATIC SENSORS
All of Oceanic Systems’ Submersible Hydrostatic Sensors are designed with piezoresistive technology. The housing is rated to IP68 and are hermetically sealed making them perfectly suited for their required application.
4670-4673 SIDE MOUNT HYDROSTATIC SENSORS
The Oceanic Systems’ Side Mount Hydrostatic Sensors works on following the piezoresistive principle and has a standard medium working temperature from -20~100°C.
3210 Dual Deck Filler Gauge
The 3210 Dual Deck Gauge displays the levels of TWO fuel tanks right at the deck fillers.
This enables the user to see the exact tank level at the point of filling. This allows the tanks to be filled without the risk of spills or wastage.
3125 Tank Sender Adaptor
It is compatible with both European standard 0-180 Ohm and United States standard 240-30 Ohm tank level senders and is accurate to ±1%.
4291 4-20mA Tank Level Adaptor
3135 VDO RESISTIVE GAUGE DRIVER
3350 DIGITAL TANK LEVEL GAUGE
3350 DIGITAL TANK LEVEL CONTROLLER
3271-SAM SENDER AVERAGING MODULE
The Oceanic Systems 3271-SAM Sender Averaging Module solves the problem of inaccurate tank level gauge readings caused by the tank contents moving to the aft of a long tank when the boat is in a bows up attitude whilst under power.
3261 SAE5 Bolt to 1.25" BSP Mounting Ring
This component is designed to allow a Tank Sender with a 1¼” BSP threaded mount to fit an SAE 5 bolt hole pattern in the tank top. It comes with both an EPDM gasket suitable for water tanks and a nitrile/cork bonded gasket suitable for fuel tanks.